This circuit can be used to indicate left and right turn on a car, motorcycle, motor-bike. Two identical circuits will be needed, one for left and one for right.
Each led will come on after previous and when all led come on - they will turn off and start from begining.
Dimensions without box:
- length - 32 mm
- width - 23 mm
- height 15 mm
Power: + , - Have protection against reverse supply voltage. (Black 12V+ and Red 12V- wires)
Outputs: Negative - (5 x white wire for each LED)
Common positive - orange wire
Direct 5 x 12V Outputs 0.10A - can carry powerful diode up to 0.5w each ( 5 x 0.5w)
If you use led 1.8V diodes must be soldered 330 ohms resistor, regarding wiring diagram
The module is for one side of the car, for two sides(left and right turn signal) need to be used 2 modules.
Power supply - 12V DC
With trimmer is adjusted the time when all diodes is on.
The module start with power on. For the led light can be used led strip, or separate diodes – for example 5 x 2 led.
Can be used water resistant 5x LED 0.5w for each side of the car
The kit is assembled and ready for use.
With Box
Package contents:
1. Turn signal module
2. Instruction for use and wiring diagram.
